What is Metal stamping – Metal Stamping machine

worker operating press punch machine for sheet metal shaping process

Sheet metal working processes are cold working processes in which forming and related operations are performed. In sheet metal operation the surface area-to-volume ratio of the starting metal is high. This ratio distinguished the sheet metal operation from bulk deformation. Often it is called press working because the machines used to perform these operations are pressed. A part produced by sheet metal operation is often called stamping.

The tools used to perform stamping operation are a set of tools called punch (smaller members) the upper half and a die (larger member) the lower half. The sheet metal is placed in between the two die halves. When the two die halves are brought together the punch enters the die and part/s is/are produced. Punch has a shape that corresponds to that of a die but is smaller by an amount determined by the required punch die clearance. Again the punch die clearance is determined by the type and thickness of the material and the operation to be

Stamping of sheet metal involves cutting or shearing, bending or forming, and drawing or deep-drawing operations. A detail of all the process has been given below.

Blanking or piercing: It involves cutting of the sheet metal along a close outline in a single step to separate the piece from the surrounding stock.

Forming: This operation produces one or more plane surfaces that are at an angle to the original or flat plane of the blank. Any change either small or big is classified as forming.

Drawing: Forming of a flat metal sheet into a hollow or concave shape, such as a cup, by stretching the metal is known as drawing.

Shaving: It is a secondary operation after blanking or piercing operation. It produces a smooth edge on the work piece instead of the breakaway edge. This is achieved by removing a small amount of stock from the edge of the part.

Trimming: It is similar to blanking but, it occurs after forming, drawing, or other operations when extra metal is left in the part for holding or locating purpose or as stock allowance. The removal of this extra stock is called trimming.

Embossing: It is used to create indentation in the sheet such as raised or depressed area with little or no change in material thickness. Making of nameplates and stiffening ribs are two applications

Read more: What is Metal stamping – Metal Stamping machine